3D model of a box for printing on Bambu Lab X2D [Administration]
Welcome!
We need a 3D model of a small box measuring 150 x 242 x 45 mm, which can be printed on a Bambu Lab X2D.
I will send the internal plan after the project is finalized. We need a *.stl
Features:
1. Everything will be in mm.
2. The walls of the box are all 3mm externally, but the front expands to 5mm closer to the top edge, and we need to embed 4 magnets measuring 6.1x3x1.8mm. The same should be done on the lid. There should be 3 layers over the magnets, that is, 0.6mm to seal them. In the middle, 2 magnets should be close to each other and at a distance of 20 mm from the edges, there should be one more magnet.
3. There are two internal hinges made of 1.5mm diameter wire (the loop should be 2mm) with a length of 50mm, sealed on one side and open on the other to insert the wire. So, the loop is 60mm. The design of the hinge should be angled so that the lid opens at 110 degrees.
4. The writing on the lid should be recessed by 0.8mm. The thickness of the lid is 3 mm. All external walls and the bottom are 3mm, while the internal partitions are 2mm.
5. The internal partitions and external edges are slightly rounded on both the lid and the box.
We would be happy to work together!
P.S. Please do not write us a low price and then "we will negotiate".
Applications 1