Ruslan Lobus
Winning proposal- Projects -
- Rating -
- Rating 232
Budget: 2000 UAH Deadline: 7 days
I will use the ADuM5241, but I will replace the pseudo-logic with field-effect transistors by the 74HC00 logic. This will increase the speed, reduce the number of components in the circuit, and eliminate the need to adjust resistors for a specific platform. It will be necessary to order the ADuM chip for me. The deadline includes the delivery time of the radio components.
Proposals are currently absent
-
Dmitro K. 5 April 2024Доброго дня. Я можливо не зрозумів суть. Тут юарта немає, що ви хочете гальванічно розв'язати?

-
Irina G. 5 April 2024вот ваш ответ
https://arduino.ua/ru/prod4832-master-shini-1-wire-s-galvanicheskoi-razvyazkoi-sdelano-v-ykraine
-
Stanislav Zhuravlov
5 April 2024
Це 1 ware через UART. Передача та читання через rx, tx. А не через один пін. Мені не підходить.
-
Irina G. 5 April 2024или вот 1wire==1wire
https://radiokot.ru/articles/58/собрано на ADuM5241 на космодроме стоит 300грн
-
Ruslan Lobus 5 April 2024Повинна працювати. Це геніальне рішення. Коли Мастер дає "0", то Т2 підтягує зворотній звязок до "1" і, тим самим, вимикає його. Коли Мастер "1", а Слейв дає "0", то Т1 підтягує прямий звязок до "1" і, тим самим, вимикає його. Ше й живлення на борту.
-
Stanislav Zhuravlov
6 April 2024
Робіть заявку на проект. Замовим ADuM5241. Сберіть, покажіть що все ок.
Current freelance projects in the category Embedded Systems & Microcontrollers
Development of a Flight Controller for Fixed-Wing UAVs An experienced Embedded Hardware Engineer is needed to develop a flight controller for fixed-wing UAVs. Tasks: develop the electrical schematic; design a multilayer PCB; select the component base; prepare Gerber, BOM, and Pick&Place for mass production. Main requirements: microcontroller STM32H743 or equivalent class; functionality similar to Matek H743-Wing V3 (without copying); compatibility with PX4 or ArduPilot; interfaces: CAN, UART, SPI, I2C, USB, PWM; support for connecting GPS, IMU, barometer, telemetry, and other peripherals; maximum use of components that meet NDAA requirements (without using Chinese components where possible). Mandatory when responding: describe your experience in developing Flight Controllers or other Embedded platforms; provide examples of completed projects; indicate which CAD systems you use (Altium, KiCad, etc.); specify estimated timelines and costs for completion. Preference will be given to contractors with experience in developing electronics for UAVs, robotics, or avionics.
There is a board with esp32, sim800l, mini 560pro 5v. It has two pulse inputs (coin, bill). 1. A 6-pin connector (mdb) needs to be made. 2. Integrate power into the board, it can be replaced with ti, Pololu D24V5F3 6-30V 3.3V / 1.5A, as a choice or integrate the existing module into the board. 3. Replace sim 800l with another module (the pins fit, but differ in places). Gerber files are available, there are no schematics, base jlpcb.
