Technical calculation and drawing of a shell-and-tube heater (AutoCAD + Word)

To design the production line, it is necessary to perform thermal and structural calculations of the shell-and-tube heat exchanger for heating the sugar solution (diffusion juice) with saturated steam.

Technical input data in the attached screenshot

What needs to be provided as output:

1. Explanatory text (in Word format) with a clear structure:

   • Introduction (a brief overview of heating and heat exchange processes).

   • Technological description of the designed apparatus and its purpose.

   • Calculation part: Thermal balance, Structural calculation (determination of heat exchange area, number and length of tubes, internal diameter of the shell), Hydraulic calculation (pressure losses, pump drive power) and Calculation of thermal insulation of the apparatus.

   • Safe operation conditions of the designed apparatus and environmental issues.

   • Conclusion and List of references.

2. Graphic part (in AutoCAD format, .dwg):

   • Drawing of the overall view of the heat exchanger (vertical or horizontal type at the engineer's choice according to calculations) with main dimension lines, nodes, and a table of fittings.

   • Equipment specification (on a separate sheet or in the drawing file).

The formatting of the text part should be neat, structured, and in accordance with the general requirements for engineering and technical reports according to DSTU.