It is required to design a printed circuit board (Gerber file). Essentially, it is not even a Gerber but a simple layout based on the description.
The board is for esp32 and pads for the necessary pins. A total of 2 such boards are needed. That is, the board has ONLY the controller and the circuitry for power supply. At the edges of the board, there are pads with labeled entry points.

I would like to complete this in 3 days.

Proposals 5

Please select

Sergei Prisaga

1 0

Projects -
Rating -
Rating 224

Budget: 50 EUR Deadline: 2 days

Hello!

I can complete the task of creating a printed circuit board for ESP32 with the necessary pin connections and power wiring. I understand that essentially a simple layout is needed with labeled pins and preparation for a Gerber file, without unnecessary components.

I am ready to:

make 2 boards according to the description;

label all input points/pins along the edges of the board;

complete it within 3 days;

provide the schematic in a convenient format for further manufacturing (Gerber/PCB).

I have experience working with ESP32 and developing simple boards for power and signals, so I guarantee clear and neat work.

I am ready to start immediately after the confirmation of the technical specifications.

Artem K.

6 0

Budget: 50 EUR Deadline: 1 day

Good day! I will complete the assigned task within the specified time, and as a bonus, I will provide a BOM and a coordinate sheet. Also, if necessary, I will help order the manufacturing in China.