Creating a BMS reading program

Embedded Systems & Microcontrollers — incorrectly specified categories?

56 USD

Client's review of cooperation with Serhii Sulik

Creating a BMS reading program

56 USD

A remarkable specialist, despite the fact that I did not make a full TZ.
He to find out and done the job perfectly.

5.0

Profile deleted

Reciprocal Feedback

15 October 2021

Freelancer's review of cooperation with client

Creating a BMS reading program

56 USD

I am pleased with collaboration with Olga.
There were some inaccuracies in the task, but this is not critical.
The customer is adequate and well understood in the subject area. I strongly recommend cooperation!

5.0

Serhii Sulik

Reciprocal Feedback

16 October 2021

Project translated automatically. Log in or register, to view the original You need to write the value reading program from the bms and the output in the serial.monitor lcd and can2 Serial monitoring of parameters 1) Stretch 1 ... Strength 98 Total voltage V 100)Tok A 101) SOU 102)maxV maximum voltage 103)maxV_n Max voltage number 104)minV minimum voltage 105)minV_n minimum voltage number Maximum maximum temperature 107) Minimal temperature 108) t1 temperature 1 ... 112)t5 temperature 5 113)Vz total of all 98 cells tensions It is necessary to ignore if there are no data. Screenshots 2004 i2c 1 time Total voltage / Minimum voltage value / Minimum value number / Maximum value / Maximum value number 2 lines The average voltage value / Delta between the minimum and maximum value Three lines Electricity / SOC 4 lines Minimum temperature/m asymmetric temperature Results in Kan2 Remove the main parameters Total voltage V 100)Tok A 101) SOU 102)maxV maximum voltage 103)maxV_n Max voltage number 104)minV minimum voltage 105)minV_n minimum voltage number Maximum maximum temperature 107) Minimal temperature In the form of can messages, one on the values, to the address 100,101 ..... Management of Rally For the values of the minimum voltage above 2.7 and the maximum below 4.15, the relay is included according to the scheme. 1) Includes the 1st 2) Late of 100ms 3) Includes the Rally 2 Retardation of 400ms 5) Includes Rally 3 Retardation of 100ms The rally 2 is turned off. If the minimum voltage is below 2.7 and the maximum is above 4.15, the relay is disabled according to this principle. 1) Inclusion of Rally 2 • Retardation of 400ms 3) disconnecting the 3 Retardation of 100ms 5) disconnecting the rail 2 Retardation of 100ms 7) disconnecting the rail 1 Charge Mode When you press the buttons, the relay (+ and -) is included for 1 minute without a sequence and despite the minimum value and maximum More information in the attached file

Proposals 2

Current freelance projects in the category Embedded Systems & Microcontrollers

Small rotary wire camera

3 proposals 29 July

112 USD
Development and refinement of PCB based on the existing layout

Mechanical Engineering & Instrument Making 4 proposals 28 July

Not specified
Development of a flight controller for fixed-wing UAVs

5 proposals 22 July

Not specified

Olga Ivanova
Dnepr, Ukraine

Projects 45
Rating 5.0
Rating 3 015

Creating a BMS reading program

Client's review of cooperation with Serhii Sulik

Creating a BMS reading program

5.0

Freelancer's review of cooperation with client

Creating a BMS reading program

5.0

Serhii Sulik

Proposals concealed

Proposals are currently absent

Current freelance projects in the category Embedded Systems & Microcontrollers

Small rotary wire camera

Development and refinement of PCB based on the existing layout

Development of a flight controller for fixed-wing UAVs