CAD Civil 3D - It is necessary to perform a vegetability assessment within the limits of ZL

General Structure 4000 × 2500 × 1200 mm Frame: profile pipe 100×100 mm Only bottom binding, no upper bindingFrame 4 corner posts (H = 1200 mm) 1 intermediate post on the long side (division 3000 + 1000) Bottom frame around the perimeter from profile 100×100 mm Clearance of the bottom binding 100 mm for lifting with a forkliftWallsLong Side 1 (4000 mm) Frame for acrylic panel Angle 80×80 or 100×100Short Side 1 (2500 mm) Blind Metal frame + sheathing with sheetShort Side 2 (2500 mm) FRAME FOR ACRYLIC PANEL Made from angle 80×80 or 100×100 No blind sheathingLong Side 2 (4000 mm, with dividing post) Section 1000 mm — blind (frame + metal) Section 3000 mm — frame for acrylic panel Bottom Frame from profile pipe 100×40 mm Completely sheathed with metal sheet Rests on the bottom bindingSummary of the Structure Acrylic surfaces: 3 sections (1 long + 3000 mm section + short side No. 2) Blind surfaces: 1 short + 1000 mm section Bottom completely metal Support on the bottom binding

The type-C must match the hole on the step model : It should look impressive for the model + don't forget about the monitor output! Best on black textolite And to avoid the obvious impression that it is not working :) (for the average user) Show me the board in the case

A compact electro-mechanical control unit needs to be developed: a motor-reducer for connecting to an existing mechanism of gears and rails, controlled by a key with smooth lighting activation. Switch key - the mechanism is such that the key is inserted into the lock - different key turns trigger different actions. 1 - turning on/off the lighting 2 - starting the mechanism for lifting the covers A motor needs to be selected that will ensure smooth movement of the gears: The entire structure is 60x60 cm, and a small motor needs to be attached, along with miniature lighting. Part of the space for this is ready - if it's not enough, we will come up with a solution based on your recommendations.

Need a professional engineer to calculate and design a modular trailer platform with a load capacity of 60 tons for a ready-made chassis. There are factory drawings. Changes need to be made.

It is necessary to integrate the NCS with the automatic launch system (catapult with a microcontroller) to transmit a signal to the microcontroller, which will initiate the operation of the catapult 500 meters away from it.