The project of the ready house to be rebuilt into two pared houses.
There is a project of a ready-made building of a area of 157 square meters.
you need to mirrorly add another one so that they touch the minimum possible, but binding according to the norms!
For example, fuel (two completely separate on the site will not be placed!). A flat roof (not flat), if somewhere there is a firewall - it's ok, it's to be painted).
I add the picture exclusively as an orientation example (this may not be attached).
There are two options,
1st roof output (that is between the walls) less than 1m. 80cm or 90cm
2. or a flat wall with a parapet (some) and one window in the sanvuzol only (I don't know if there is such a concept as a mirror)
The ?
The whole area is under construction.
the problem is that it is not possible to place two separate houses (in the sum of 8 hundred, and for each individual it should be 5 hundred),
So you need to go on the wall (not on the wall).
I add the plan of the second floor and the idea with a little drowned room between the houses
Чи можна зробити от так?
тут два варіанти,
1. виступ даху (той що між стінами) менше ніж 1м. наприклад 80см або 90см
2. або взагалі плоска стіна з парапетом (якось) і одне вікно в санвузол лише (незнаю чи є таке поняття як вогнотривке)
?
ділянка вся під забудову
проблема в тому що неможливо розмістити два окремі будинки (в сумі 8 соток, а на кожен окремий ніби треба 5 соток),
тому потрібно якось спарити (не по суцільній стіні)
додаю план другого поверху і ідею з втопленими чуть чуть приміщеннями між будинками
Applications 5
-
482 Good day !
The cost of the project in 2 sections, Architecture and Construction will be approximately 45g/m2.
I will be able to get more accurate after getting acquainted with the existing project.
-
321 Good day, I can do my job. Send a project for acquaintance. Where is the registration number of the address?
The cost of the section AB and KB will be sent in a private message, in case it will need to change the house. Only consultation and clarification of whether the construction agreement will be possible will take from 1 day to a week. 30 days - this is the deadline for the implementation of the architectural part of the project - plans, cutting, facades; and the schemes of plans to build the area. Certified architect, I have designed and built for more than a decade, I am in the Lviv region.
-
258 4 0 1 Good morning, I can perform your project, with visualizations and layout, standards depending on the area and destination.
-
1303 10 0 Good day, I offer my services to architect and interior designer.
Everything we need will be discussed in private messages.
Thank you, I'm waiting for your answer.
Congratulations to Vitaly!
Link to work:
Behance(Vitalii-Baskakov)-proekt-eksterru-budinku
Behance(Vitalii-Baskakov)-proekt-eksterru-budinku
Behance
Freelancehunt
-
1016 20 0 Good evening, I am pleased to fulfill your task, I have experience in modeling and designing architecture both private and industrial buildings and buildings!)
I am ready to talk and talk!)
-
А які межі самої ділянки?
Чи є можливість зробити парапети на покрівлі (по стінам котрі будуть навпроти)?
Будете будувати тільки будинку поруч, чи з нуля обидва?
Чому не розглядаєте можливість розташування стик в стик?
Буду вдячний за відповіді.
-
1. Додав ділянку, там ширина макс 27м
2. Та мабуть можна, цікаво як воно би виглядало
3. З нуля обидва
4. Стик в стик не підходить (так не подобається і все, така ідея), має бути повітряний простір. Ніяких шумоізоляцій не існує (це все повна маячня). -

Так блокувати будинки можна, але є певні нюанси. Перший — або це буде по документах один будинок (бажано площею до 500 кв.м., щоб по буд.паспорту), або розділити ділянку надвоє (причому площа кожної з ділянок має бути не менше 150 кв.м.). І на кожній з частин поставити по блокованому будинку.
Якщо робити окремостоячі будинки, то відстань між ними має бути 6-8 метрів, залежить від конструктиву будинку та наявності вікон у межуючих стінах.
Щодо блокування і внутрішньої ніші між будинками. Її варто робити шириною не менше 3-3.5 метра. А краще 4 і більше. Інакше, якщо буде дуже вузька, то це буде просто мертва площа, до того ж там будуть проблеми з водовідведенням, снігові мішки, та й просто темно, вогко та незатишно. Який функціонал цієї тераси зверху? Врахуйте що зробити плаский дах та відвести звідти воду — це вимагає якісних та продуманих рішень.
-
Current freelance projects in the category Architectural Design
Point cloud to Revit (A3852)For a future architectural project, it is necessary to model a building and the land with roads and stairs from a point cloud. Develop a 2D drawing with the main dimensions, total and living areas of the premises. Output data can be found at the link:… Architectural Design, Drawings & Diagrams ∙ 2 days 6 hours back ∙ 3 proposals |
Point cloud to Revit (A3738)For the future architectural project, it is necessary to model the building and the land with roads and stairs using a cloud of points. The roof of the adjacent building also needs to be modeled. Develop 2D drawings with the main dimensions, total and living areas of the… Architectural Design, Drawings & Diagrams ∙ 2 days 6 hours back ∙ 1 proposal |
Visualization of sliding gate and fence models for the catalog and website
28 USD
We need a specialist who can prepare a series of high-quality images of sliding gates, gates, and fences in a unified style for a product catalog and future website page. Important: this is not just photo processing and not just cutting out gates on a white background. We need… 3D Modeling, Architectural Design ∙ 3 days 7 hours back ∙ 23 proposals |
Design project of a one-room apartmentTechnical task for the development of a design project for a one-room apartmentGeneral information A complete design project for a one-room apartment needs to be developed, taking into account modern solutions, space ergonomics, and the preparation of a set of drawings for the… Architectural Design, Interior Design ∙ 3 days 9 hours back ∙ 28 proposals |
Development of a working project for engineering networks of a private house 300 sq.m.
601 USD
Looking for an engineer/company to develop a working project for the engineering networks of a private house in the village of Lisnyky (Kyiv region). Necessary sections of the project: EO (Electricity): power networks, lighting, panels, grounding. HVAC (Heating and… Engineering, Architectural Design ∙ 3 days 10 hours back ∙ 3 proposals |