Development of project documentation for the manufacture of the pressing field

Task Description: There is a completed project and a budget prepared in the AVK-5 program. It is necessary to professionally adjust the budget and reasonably align it with the specified final amount. Requirements: check the existing budget; adjust the scope of work, rates, materials, and other expenses within the project documentation; bring the total cost to the specified amount; maintain the logical consistency and correctness of all calculations; provide the final budget in AVK-5 format and PDF/Excel; if necessary, briefly explain which items were changed. Important: the budget must remain realistic, technically justified, and suitable for verification, without artificial or unjustified items.

Design a technological line with equipment selection and calculation of all premises. The composition of the technological equipment:- universal glazing line 600mm 1000 kg/shift- one-shot line for fruit fillings 1000 kg/shift- fitness bar line with grain puffing separation 1000 kg/shift- dragee line 500 kg/shift- craft products department 250 kg/shift- chocolate production department from semi-finished products 1000 kg/shift

There is a vending machine (Necta Sfera H-1.8), it needs to be physically inspected and audited. The tasks are as follows: connecting a new controller (if necessary) power supply; wiring; sensors; new modules. Payment is negotiable The work is physical, we are in the center of Kyiv. 10-14 days are allocated for the work, no more

There is a vending machine (Necta Sfera H-1.8) - it needs to be inspected and prepared for full operation. Main tasks: 1. Modification of the dispensing mechanism (possibly) 2. Replacement of spirals (possibly) 3. Manufacturing of guides (possibly) 4. Refinement of the dispensing tray and adjustment for our product categories 5. Implementation of mechanical contactless and contact payment methods (mandatory) The work is physical, we are in the center of Kyiv. Time for this work: 10-14 days, no more Payment from FOP to FOP (preferably have). Payment is negotiable.

Drawings and material list. For a canopy for the installation of solar panels. A canopy for storing equipment and vehicles. Installation site: s. Zhemchuzhnoe, Pavlohrad district, Dnipropetrovsk region, angle of about 10 degrees. Long panels 620 (230 by 113), needed in two rows about 19 meters in length available. So a frame is needed for the installation of the panels only without covering; the joints of the panels will be sealed later with rubber gaskets. It should withstand wind and snow loads. It is not standing in an open field, there are small buildings nearby, but it is outside the city and on a decent slope. A galvanized mounting profile has already been ordered, with a thickness of 1.4 mm, and it needs purlins about 1 m. So, it will probably be necessary to install a profile pipe to reinforce it, to reduce the number of beams, I think, to minimize deflection. It was planned for installation on the roof, but the roof turned out to be not quite convenient for such installation.